Mobile jammers can make us rest better

In recent years, with the rapid development of mobile phones, it is not uncommon for students to use mobile phones to affect their lives and studies. Many teachers who inspect the dormitory at night say that they often find some students use their mobile phones to go online in the bed, some even in the middle of the night. It is still at one or two o’clock, so in order to prevent students from playing with their mobile phones in the middle of the night and let them have a better rest, many schools have to choose to install mobile cell phone signal jammer in their dormitories.

So, is it sufficient to put a mobile phone jammer in each room in the school dormitory like the school examination room? Actually, how to choose and install is explained below. The cell phone jammers installed in school dormitories are mainly used at noon and evening when students are resting. Noon is usually 11:30 to 1:30, and at night is 10:30. Until 2 o’clock in the morning. That is to say, it is not required that the mobile phone signal is shielded for 24 hours without interruption. Then the mobile phone jammer with ordinary power supply such as an external adapter can also be selected.

During installation, it is recommended to connect a timer switch to set the time required to work. At that time, there is no need for manual control, and the mobile phone signal jammer can be automatically turned on when it needs to work. Effective segmentation, only interferes with the downward installation height: 1.0-2.0 meters is the best effect, low energy consumption, energy saving and environmental protection, while not posing a threat to the health of students and staff. How to choose a mobile phone jammer suitable for dormitory use When turned on, students’ mobile phones will turn into bricks. Of course, students hate it. Therefore, mobile phone jammers cannot be placed in the dormitory, even if they are placed in the dormitory without wall shielding. It will be stronger, but it won’t work, because students will unplug the power plug or even damage it.

Therefore, if you use a small cell phone signal jammer, it is usually placed under the wall monitoring of the corridor outside the dormitory. Since the signal will be attenuated through the wall, try to choose a mobile phone signal jammer with a metal shell and an external antenna, and the power should be as large as possible. Then you have to put one every ten meters or so. This is the case on every floor. Let the signals of these mobile phone jammers form a network, which will be much better than using a mobile phone signal jammer alone. In the final installation, all The mobile phone jammer is connected with a power cord, connected to a master switch, and can be controlled together when using it.

How to install shielding equipment correctly? In fact, schools are more willing to install high-power mobile phone signal jammers outside the dormitory building, which saves electricity, is convenient to control, and has low radiation. It only needs to install points on the adjacent buildings more than ten or twenty meters to interfere with the mobile phones. If there is no adjacent building that can be fixed, then a metal pole can be erected on the ground, or if there is a monitoring pole, it can also be fixed on the monitoring pole. After the main body of the mobile phone signal jammer is fixed, the antenna can be erected. You only need to point the antenna toward the building that needs to be shielded, and then adjust the angle and it can be used normally. Note that you must choose a high-power mobile phone signal jammer that is waterproof and rainproof.